Setting/Adjusting - HANSGROHE PHARO EL40 26945000 Montageanleitung

Displaying/changing
program items (factory
settings)
Upper reset limit
+
1
2
3
4
/
5
6
Lower reset limit
7
8
/
9
10
Upper setting limit
11
12
/
13
14
Various basic settings of the
system are preset at the factory
and can be changed within the
allowed limits.
To display the program menu,
press the >42° + Shower
lighting (1) buttons at the
same time for at least 5 sec-
onds until PAR (2) is dis-
played. Press the MODE (3)
button. P00 , the program item
for the upper reset limit, is
shown on the display. The
value 42°C is displayed when
the MODE (4) button is
pressed again. Use the +/- (5)
buttons to adjust this value
within the range 32°C to
42°C. Store this setting with the
MODE (6) button. The display
shows P00.
Press the + (7) button to
display the next program item
P01, the lower reset limit. The
value 32°C is displayed when
the MODE (8) button is
pressed. Use the +/- (9)
buttons to adjust this value
within the range 10°C to
32°C. Store this setting with the
MODE (10) button. The
display shows P01.
Press the + (11) button to
display the next program item
P02, the upper setting limit of
the shower temperature. The
value 55°C is displayed when
the MODE (12) button is
pressed. Use the +/- (13)
buttons to adjust this value
within the range 40°C to
60°C. Store this setting with the
MODE (14) button. The
display shows P02.

Setting/Adjusting

The upper reset limit is the
maximum value of the shower
temperature and is stored after
the last shower and set as start
shower temperature when the
shower is used again.
The lower reset limit is the
minimum value of the shower
temperature and is stored after
the last shower and set as start
shower temperature when the
shower is used again.
The upper setting limit is the
highest temperature that can be
selected when using the
shower.
33