Installation - Klarstein 10028129 Bedienungsanleitung

G Display At normal condition, the number in the window is on always, it means the ambient
temperature; And if the number flashes, it will display the left time in minute of each
process, like each ice-making cycle, self-cleaning program, etc.
H ON/OFF
When the unit is off, press this button to turn on the unit; And during the Self-
cleaning program, or normal ice-making state, press this button to turn off the unit
at once; And also if the unit is set with the Timer, press this button to cancel the
Timer setting. When the unit is making the ice cube, press this button for more than
5 seconds, the unit will switch to ice harvest process by force.
I TIMER/ Quickly press this button once, to enter the Timer setting program; And press this
CLEAN button for more than 5 seconds, to enter the Cleaning program.
Before First Use
• Remove the exterior and interior packaging. Check if all the accessories, including instruction
manual, ice scoop, white water inlet pipe, 4 ways to 2 ways water quick connector and the water
draining pipe, etc., are inside or not. If any parts are missing, please contact our customer service.
• Remove the tapes for fixing the door and inned cabinet, ice scoop, etc.. Roughly clean the inner
cabinet & ice scoop with wet clothe.
• Put the ice maker on a level & flat floor, without direct sunlight and other sources of heat (i.e.:
stove, furnace, radiator). Maker sure that there is at least 20cm gap between the air outlet and the
obstacles, and at least 5 cm between Left/Right side and the wall.
• Allow 4 hours for the refrigerant fluid to settle before plugging the ice maker in if the unit maybe
fall upside down during shipping or transportation.
• The appliance must be positioned so that the plug is accessible.
• Connect to the potable water supplying only. Only use drinking water.

Installation

• This unit is not for outdoor use.
• Keep the proper room temperature and inlet water temperature accor-
ding to above specification table. Otherwise it will affect the ice making
performance.
• This unit should not be located near any heat resource.
• The unit should be located on a firm & level foundation at normal counter
top height.
• There must be at least 15CM clearance at rear side for connection and
20 CM clearance in front to open the door and keep good air circulation..
• Do not put anything on the top of the ice maker.
Electrical Requirement and Connections
• Plug into a grounding wall outlet.
• Use separate power supply or receptacle.
• Never use an adapter or an extension cord.
• Before you move your ice maker into its final location, it is important to make sure you have the
proper electrical connection. It is recommended that a separate circuit, serving only your ice ma-
ker, be provided. Use receptacles that cannot be turned off by a switch or pull chain. If the supply
cord or plug to be replaced, it should be done by a qualified service engineer.
• This appliance requires a standard 220-240Volt, 50Hz electrical outlet with good grounding means.
15
Installation