Operating Modes; Installation - roco 10745 Bedienungsanleitung

Tipps
Auch die digitale ROCO Anlagensteuerung ROCOMOTION (Art.-Nr. 10785) bietet vielfältige Möglichkei-
ten. Infos über ROCOMOTION erhalten Sie im Fachhandel oder unter „www.roco.cc".
Digital Locomotive Decoder (DCC)
 Automatic detection of speed steps (14 / 28 / 128)
 Capable of being updated
 Overload protection of all outputs
 Automatic detection digital – analog
 Functions that can be activated:
F1: Special function (= green wire, i.e. smoke generator)
F3: Shunting mode (= half speed)
F4: Deactivate set values for braking or acceleration

Operating Modes

 Digital multi-train operation with NMRA compatible systems as:
– Lokmaus 1 (art. no. 10750)
– Lokmaus 2 / PowerMouse, Lokmaus R3 (art. no. 10760, 10860, 10790 und 10792)
– multi MAUS (art. no. 10810)
– ROCOMOTION (art. no. 10785)
 H0 DC locomotives with a decoder interface according to NMRA S 9.1/9.2 and NEM 650/652
The use of this decoder in other than the previously listed digital systems or in power units which are not
factory-equipped with NMRA or NEM (see above) conforming decoder interfaces (installation by e.g. cutting
the interface plug and soldering of the decoder into the locomotive) can cause irreparable damage to the
decoder or the locomotive. ROCO cannot be held liable in such events for the decoder or the locomotive or
any guarantee. Damage caused by any other changes to the decoder (e.g. applying paint) are also excluded
from any guaranties.
The use of 12 volt bulbs during digital operation can cause irreparable damage (melting) to the locomotive
housing!
Installed 12 volt bulbs must be changed to 16 volt bulbs (already installed in locomotives starting with fabrication
year 2000). 16 volt bulbs can be obtained through stockists or our service department. Compare with the installed
bulb shown in the locomotive replacement parts listing:
art. no. 108616: bulb with attached leads, white 16 V replaces art.no. 93520 12 V
art. no. 109918: bulb with attached leads, red (only 16 volt version)
art. no. 109088: plug-in bulb, small 16 V, replaces art.no. 93518 12 V
art. no. 93734: tubular bulb 16 V, replaces art

Installation

(required only if decoder was bought separately)
Take precautions to protect against hazardous static discharges. If you have ESD (electrostatic discharge) equip-
ment available, then use it. Otherwise make sure that you do not touch the pins on the connector!
All installation work must be done on vehicles removed from the track. The locomotive must be in perfect electri-
cal and mechanical condition. Parts subject to wear e.g. motor brushes, wheel contacts, have to be cleaned or
replaced!
8010745920 III_2009.indd 5
.no. 93517 12 V
GB
5
30.01.2009 07:31:27