Amann Girrbach ceramill UV Originalbetriebsanleitung Seite 6

gB
adjustment of sensitivity
The sensitivity of the sensor depends on the
lighting conditions in the workplace. It might be
necessary, therefore, to adjust the sensitivity.
Please carry out any adjustments carefully
using an Allen key (2 mm), as shown in Fig. 3.
_ More sensitive: turn in an counter-clockwise
direction
_ Less sensitive: turn in a clockwise direction
3
The sensor is optimally set when the polymeri-
sation-LED switches on at a distance of approx.
20-30 mm. The final position (last setting in a
clockwise direction) should not be selected
since this setting is not adequately sensitive.
MaIntenance/care
Pull out the plug!
The machines are basically maintenance-free.
When cleaning, keep the device dry.
cautIOn! Do not allow evaporation and do not
clean with water or solvents.
6
technical data:
D/B/H: 145 x 300 x 30 mm
(gooseneck 800 mm)
Weight: 2,6 kg
Main supply: 110 – 230 V 50/60 Hz
Initial value mains
adaptor: 7,5 V, 1,2 A
Polymerisation-LED: 600 mW, 450 - 470 nm
Packing list:
Order No.:
178200 Ceramill UV
inc. mains adaptor
visor
Polymerisation-LED
accessories/components:
Order No.:
178201 Mains adaptor 110 - 230 V
178210 Ersatz LED
178211 Blendschutz