Assembly The Wall Holder; Fastening The Wall Holder - Afk HVC-150.55R Bedienungsanleitung

Assembly the Wall Holder

Inserting the Plug of the Power Supply Unit
If you want to use the wall holder also as the charging station,
attach the plug of the power supply unit first. Refer to the
illustrations (A to C) on page 21.
NOTE:
7XUQ WKH SOXJ DW WKH PHWDO HQG QRW DW WKH FDEOH 8VH D
pliers if necessary.
7KHUH LV DQ RSHQLQJ DW WKH UHDU RI WKH ZDOO KROGHU <RX FDQ
the plug additionally with a finger through this opening.
1. Set the plug of the power supply unit with the flattened side
into the wall holder. (Fig. A)
2. Turn the plug of the power supply unit by 90 °. It must sit
solidly in the holder and sliding no longer shall be
possible. (Fig. B)
3. Fix the cable in the cable guide. (Fig. C)

Fastening the Wall Holder

WARNING:
Make sure beforehand whether there are cables in the wall
which could be damaged!
CAUTION:
Place the wall holder so that the appliance is not exposed to
direct sunlight or other heat sources.
NOTE:
A power outlet must be near.