Fault Codes - KLARSTEIN CLEANMATE 10033188 Bedienungsanleitung

Notes: If the problem has not been solved:
1 Separate the appliance from the mains supply (deactivate or unscrew fuse)
2 Contact the costumer service. Do not attempt to repair the appliance yourself.
There are no customer service items inside of the appliance.
3 Relieve in force: When oven door is locked, and sensor is abnormal not a door
lock problem, press and hold the clock button (K2) and the pause/cancel
button (K4) at the same time under standby status. Door lock will be released
in force when hearing a "di" sound, door lock icon (10) will extinguish and the
oven door can be opened. The door lock function is invalid.
4 After oven door lock was released in force, the oven must be cut off and
reconnected, door lock will self-check again during the connection, oven can be
used normally afterwards.

FAULT CODES

Error code
E 1
E 2
E 3
Cause
Sensor short-circuit or
sensor not connected.
The temperature inside
the oven is still below
35 °C after 5 minutes of
heating, which means
that the heating element
may have a problem.
During the self-test, the
unit has determined that
the oven door is open or
not properly closed.
Possible Solution
Press the pause/cancel
button (K4) to put the
unit into standby mode.
Contact costumer service
if the problem persists.
Press the pause/cancel
button (K4) to put the
unit into standby mode.
Contact costumer service
if the problem persists.
Press the pause/cancel
button (K4) to put the
unit into standby mode
and close the oven door.
Contact customer service
if the problem persists.
EN
75