KLARSTEIN CLEANMATE 10033188 Bedienungsanleitung Seite 61

• If electricity is cut off during self-cleaning process, oven door will be unlocked only
after power on again. (Even if power on again, oven door will be automatically
unlocked only when cavity temperature is below 300 °C.)
• During other function mode working, if oven temperature is abnormal, the oven
door will be relieved only when cavity temperature is below 300 °C.
Protection function
• The display will show "E-1", if the sensor is short circuit or open circuit under
cooking mode and the buzzer will continuously prompt for 10 times,1s/time (refer
to display effect below). The oven will be locked at this time. Touch the pause/
cancel button (K4) can return to standby modus.
Sensor abnormal alarm display effect
• When the temperature is above 35 °C after 5 minutes of heating, except for defrost
mode and Eco mode, it means the heating element has a problem. The display will
show "E-2" and the buzzer will continuously prompt for 10 times,1s/time (refer to
display effect below). Touch the pause/cancel button (K4) can return to standby
status at this time.
Heat element abnormal alarm display effect
1 During self-check after power on, if door lock correct signal is not detected for
20 seconds when door is locked into place, and display screen shows fault code
"E-3", indicating a failure of the door lock.
2 During self-check after power on, if door lock correct signal is not detected for
20 seconds when door is not locked into place, and display screen shows fault
code "E-3", it means oven door is not close to place.
3 During self-cleaning process, if display screen shows fault code "E-3" when door is
locked into place, it means door lock has a failure.
EN
61