KLARSTEIN CLEANMATE 10033188 Bedienungsanleitung Seite 53

Before first use
• To remove the new cooker smell, heat up the oven when it is empty and closed. An
hour of top/bottom heating at 250 °C is ideal for this purpose.
• Ensure that no packaging remnants have been left in the cooking compartment.
• Ensure the room the oven is installed in is well ventilated by opening doors and
windows during this process.
1. Use the function selector to set top/bottom heating.
2. Set the temperature selector to 250 °C. After 1 hour, switch off the oven. To do so,
turn the function selector to the off position.
3. Before you use the accessories for the first time, clean them thoroughly with hot
soapy water and a soft dish cloth.
Power on
• Connect your appliance to the mains supply.
• All indicator lights of the display board will light up for 1sec and then remind the
user to input the time.
• Default time indicates 12:00, the hour 12 will flash, the time can be input at this
stage (refer to the „Setting the clock" section for more details).
• After 10 sec without any operation and the display will change to adjust minute.
• Within 10 sec without any operation when adjusting the minutes, the oven will enter
standby mode automatically.
• Under standby mode, if there is no any operation in 5 minutes, the oven will switch
off automatically, and the display screen extinguishes.
• When the oven is switched off, you can change to standby mode by means of key
or programming switch (KB1).
• The standby mode displays the system time and the clock icon (9). (Refer to the
picture below for the display effect.)
• When oven is powered on, the oven door lock will start to self-inspection. During
the self-examination, the door lock will run back and forth automatically.
• If there is no abnormal alarm within 20 seconds, then self-inspection is completed.
Or if it shows fault code "E-3" during the self-inspection, please refer to protection
function for problem analysis (see section „Protection function" in chapter
"Operating functions"). You can touch the pause/cancel button (K4) to cancel the
fault code and return to standby mode.
Initial standby mode
EN
53