Hameg Instruments HM8001-2 Handbuch Seite 12

General information
The operator should not neglect to carefully
read the following instructions and those of the
mainframe HM8001-2, to avoid any operating
errors and to be fully acquainted with the
module when later in use.
After unpacking the module, check for any
mechanical damage or loose parts inside.
Should there be any transportation damage,
inform the supplier immediately and do not put
the module into operation.
This plug-in module is primarily intented for use
in conjunction with the Mainframe HM8001.
When incorporating it into other systems, the
module should only be operated with the
specified supply voltages.
Safety
This instrument has been designed and tested
in accordance with IEC Publication 1010-1,
Safety requirements
equipment for measurement, control, and
laboratory use. It corresponds as well to the
the CENELEC regulations EN 61010-1. All case
and chassis parts are connected to the safety
earth conductor. Corresponding to Safety Class
1 regulations (three-conductor AC power cable).
Without an isolating transformer, the
instruments power cable must be plugged into
an approved three-contact electrical outlet,
which meets International Electrotechnical
Commission (IEC) safety standards.
Warning!
Any interruption of the protective conductor
inside or outside the instrument or
disconnection of the protective earth
terminal is likely to make the instrument
dangerous. Intentional interruption is
prohibited.
The istrument must be disconnected and
secured against unintentional operation if there
is any suggestion that safe operation is not
possible. This may occur:
• if the instrument has visible damage,
• if the instrument has loose parts.
• if the instrument does not function,
• after long storage under unfavourable
12
for electrical
circumstances (e.g. outdoors or in moist
environments),
• after excessive transportation stress
(e.g. in poor packaging).
When removing or replacing the metal case,
the instrument must be completely
disconnected from the mains supply. If any
measurement or calibration procedures are
unavoidable on the opened-up instrument,
these must only be carried out by qualified
personnel acquainted with the danger involved.
Symbols as Marked on Equipment
ATTENTION refer to manual.
DANGER High voltage.
Protective ground (earth) terminal.
Operating conditions
The ambient temperature range during
operation should be between +10°C and +40°C
and should not exceed -40°C or +70°C during
transport or storage. The operational position
is optional, however, the ventilation holes on
the HM8001 and on the plug-in modules must
not be obstructed.
Warranty
Before being shipped, each plug-in module
must pass a 24 hour quality control test.
Provided the instrument has not undergone any
modifications Hameg warrants that all products
of its own manufacture conform to Hameg
specifications and are free from defects in
material and workmanship when used under
normal operating conditions and with the
service conditions for wich they were
furnished.The obligation of HAMEG hereunder
shall expire two (2) years after delivery and is
limited to repairing, or at its option, replacing
without charge, any such product which in
Hamegs sole opinion proves to be defective
with the scope of this warranty.
This is Hamegs sole warranty with respect to
the products delivered hereunder. No