jedo NEVO Bedienungsanleitung Seite 11

14. Backrest adjusting in carrycot
Backrest adjusting is performed by using the knob loca-
ted in the rear, lower, outer part of the carrycot. (Fig. 16)
15. Five-point safety belt adjusting
The seat is equipped with five-point safety belts. To
install the belts on the seat, put the ends of the harnesses
(plastic buckle) through the holes located in the seat
backrest, under the fabric, and through the metal handles
located on the both sides of the seat.
In the same way, we mount the part of the belt located
between the legs of the child. This should be used from
the day when a baby starts to sit up unaided. Taking the
forks out from the central buckle, undo the belts. Place
the baby, adjust the length of the belts so as they are
close to baby's body, but they must not oppress the
baby. Then plug the forks of all the belts into the central
buckle (Fig. 17).
The seat has an additional crotch strap which must be
pinned to the frame with a snap. This is an additional
element and does not exempt from the application of
5-point safety belts.
Warning! Always use the safety belts if the child can sit
unaided.
16. Setting of suspension stiffness
The stroller has got adjustment of the stiffness of rear
suspension. To adjust it, move the lever under the shock
absorber spring (Fig. 18, 19). This action should be made
on both rear wheels. The suspension has two settings:
hard and soft.
17. Rain cover
The stroller is equipped with rain cover and vent. To
mount it, pull one end into the hood and the other at the
end of the carrycot.
18. Mosquito net
The carrycot is equipped with a mosquito net. To mount
it, stretch one end into the hood, next undo the Velcros
or snaps, located on the both sides of the hood, and
attach mosquito net "ear" to the snap or Velcro (Fig 21).
Fasten the snap or Velcro and pull the other part of the
net on the carrycot.
19. Installing of car seat
The stroller is also offered in version with the car seat
for children weighing from 0 to 13 kg. To install the seat,
the adapters must be first attached to stroller rack/frame
plugging them identically as in case of carrycot. Next put
the seat on the adapters, it connects automatically.
Warning ! Before using the seat, make sure that the
adapters are installed properly.
After installing of the adapters you can start to install
the child seat. It is installed identically as in the case of
carrycot.
Warning ! Before using the child seat, make sure it is
installed properly.
To take the adapters out, you should press
the plastic buttons located on both sides of the seat.
The strollers of JEDO make, with adequate
adapter, one should mount the following seats:
1. Adapter
- Maxi – Cosi : Cabriofix, Citi, Pebble
- Cybex: Aton 3, Aton 4, CBX
- Kiddy: Evolution Pro2,Evo- Lunafix
- Safety 1st : Mimas
- Recaro: Privia
2. Adapter
- Recaro: Young Profi Plus
3. Adapter
- Römer Baby Safe Plus
- Römer Baby Safe Plus SHR II