Product Description - Renfert Silent compactCAM Schnellstartanleitung

► The mains plug must be easily accessible.
► Disconnect the device from the mains before carrying out work on the electrical parts.
► Check connection cables (such as power supply cords), tubes and housing (i.e. the key-pad)
EN regularly for damage (i.e. kinks, cracks and porosity) or signs of ageing. Devices with damaged
connection cables, tubes or housing parts or other defects must not be operated!
► Defective devices must be put out of service immediately. Remove the mains plug and ensure the
device is not used. Send the device for repair!
► Only operate the device under supervision.
► Please observe the national accident prevention regulations!
► It is the responsibility of the operator that national regulations during operation and regarding
a repeated safety inspection of electrical equipment are complied with. For Germany these are
the regulation 3 by DGUV (German Statutory Accident Insurance) in relation with VDE 0701-0702
(Association for Electrical, Electronic and Information Technologies).
► Information on REACH and SVHC is available on our website www.renfert.com, in the Support
area.
Specific Information
► When connecting to a CAM system, please observe the CAM device instructions for use and com-
ply with their safety precautions.
► Please observe the national regulations and permitted exposure to dust in a working environment.
Please ask the "National Institute for Occupational Safety and Health" or other responsible au-
thority.
► Always refer to the relevant safety data sheets, when extracting hazardous materials.
► Always wear protective gear, when extracting hazardous materials.
► It is necessary to wear suitable personal protective equipment when emptying the dust drawer or
cleaning, depending on the type of extracted material.
► When disposing of the extracted material or used filter, please observe the local specifications
and accident prevention regulations!
► Make sure the dust drawer is fully closed during operation.
► Do not operate without a suction hose.
► Do not extract flammable or explosive gasses, fumes or dust.
► Do not extract hot materials.
► Do not extract liquids.
► If the dust extractor is employed to extract hazardous materials, appropriate personal protective
gear must be worn and steps must be taken to ensure that the exhaust air is properly ventilated.
Please refer to the associated safety data sheets for specific requirements.
► Dispose of extracted material according to local statutory regulations.
Authorized Persons
Operation and maintenance of the device may only be performed by qualified personnel.

Product Description

Components and Functional Elements
See Fig. 1 (on inside cover)
1 Silent compactCAM
2 Key-pad
3 Dust drawer
4 Fine filter
5 Mains cable
6 Suction hose
7 Exhaust air filter / exhaust air outlet
See Fig. 2 (on inside cover)
20 Display CAM-mode
21 Key operating mode, CAM-mode /
continuous operation
22 Display continuous operation
8 Suction port
9 On / off switch
10 Power supply
11 Device protection switch
12 CAM interface
13 Service flap
23 Selection key
24 Display empty suction drawer
25 Enter key, save input
26 Display error message
- 2 -