Exchanging Diaphragm; Replace Unit Connection Line - WAGNER Super Finish 21 Betriebsanleitung

Repairs on the unit
11.5
exchanGinG diaphraGm (FiG. 24)
Switch off unit.
pull mains plug from socket before repair.
Danger
1. Unscrew both screws (1) from the hood (2).
2. Screw hexagonal screws (3) from the flange ring (4) with
spanner 19 mm.
3. Remove paint section (5).
4. Remove insert (6) and diaphragm (7).
5. The diaphragm can only be used
diaphragm.
•
Before mounting, clean and dry diaphragm, insert and built-in
areas on screw flange (8) and on paint section (5).
Mounting takes place in teh reverse oder
6. First of all tighten hexagonal screws (3) with 10 Nm, then
crosswise with 70 Nm.
3
5
6
7
4
8
40
GB
once. Always replace
2 1
11.6
replAce unIt cOnnectIOn lIne (fIG. 25)
Switch off unit.
pull mains plug from socket before repair.
Danger
1. Dismount trolley or frame.
2. Unscrew nameplate (1) from the front of the housing.
3. Screw off housing half with socket and remove.
4. Loosen cable connection (2).
5. Loosen cord in the mains connection terminal (3).
6.

Replace unit connection line.

2 3
1
Super Finish 21 • 23