Cleaning Unit From Outside; Suction Filter; High-Pressure Filter (Accessory) - WAGNER Super Finish 21 Betriebsanleitung

minutes.
8. Close the relief valve, valve position
9. Pull the trigger guard on the spray gun.
10. Pump cleaning agent into a open container until the unit
is empty.
11. Open the relief valve, valve position
12. Switch off the unit.
8.1

cleAnInG unIt frOM OutSIde

first of all pull out mains plug from socket.
Danger
danger of short circuit through penetrating
water! never spray down the unit with high-
pressure or high-pressure steam cleaners.
Danger
do not put the high-pressure hose into sol-
vents. use only a wet cloth to wipe down
the outside of the hose.
Danger
Wipe down unit externally with a cloth which has been im-
mersed in a suitable cleaning agent. Clean socket and the ON/
OFF switch areas meticulously also.
8.2

SuctIOn fIlter

Clean filters also guarantee the maximum con-
i
veyance quantity, constant spraying pressure
and faultless function of the unit.
•
unit with suction system
1. Screw off the filter (fig. 15) from suction pipe.
2. Clean or replace the filter. Carry out cleaning with a hard
brush and an appropriate cleaning agent.

•
unit with upper hopper
1. Release screws with a screwdriver (fig. 16, item 1).
2. Lift (2) and remove filter disk with a screwdriver.
3. Clean or replace the filter disk. Carry out cleaning with a
hard brush and an appropriate cleaning agent.
Super Finish 21 • 23
GB

(spraying).
(circulation).
8.3
•
Open the relief valve, valve position
•
Switch off the unit.
•
Open high-pressure filter and clean filter insert; in addition:
1.
2.
3.
4.
5.


hiGh-preSSure Filter (acceSSory)

Insert open-ended spanner into the groove of the filter
housing (fig. 17, item 1) – screw out filter housing.
Remove filter housing (1), supporting part (2), centring
ring (4) and O-ring (5).
Roll in filter insert (3) (for filter insert with 70 mesh this is
not necessary) and pull out of supporting part (2).
Clean all parts with appropriate cleaning agent. If
pressure air is existent – blow through filter insert and
supporting part.
Remount high-pressure filter.
Cleaning unit
1
2
(circulation).
1
2
3
4
5
35