Installation Instructions - Schütte 10025 Montageanleitung

Installation instructions

GB
Dear customer,
You have purchased a high-quality and
long-lasting product from our line of goods.
Please read these instructions carefully before
assembling and observe the notes.
These instructions contain important infor-
mation on installation, adjustment, care, and
spare parts.
Therefore, keep the instructions in a safe place
and pass them on to possible subsequent
owners.
Safety notes
• Please only allow qualified persons to carry
out the installation.
• CAUTION: WATER DAMAGE! Please shut off
the general water supply prior to installation.
• Make sure that all seals are correctly fit.
• Only suitable for use in rooms with a
temperature over 0° C – shut off water
supply when there is a risk of frost
• Despite careful production, sharp edges can
occur. Please exercise caution!
Disposal
Your shower drain is delivered in a solid
packaging, in order to protect it against
transport damages. The packaging consists
of recyclable materials. Dispose it in an env-
ironmentally suitable manner.
Do not throw the product into the normal
domestic waste at the end of its service life,
but ask your municipal administration about
the possibility of an environmentally friendly
disposal.
Installation Instructions
• Mark the placement of the shower channel
based on the planned installation location
• For a direct wall mounting, the factory-
formed thin-bed flange is slid as far as up to
the finished wall to ensure adequate sealing
• Align the shower channel horizontally
• The connection piece of the odour trap
housing fits all insertion pipe coupling
systems DN 50
• In order to prevent the contamination of
or damage to the rust surface, this surface is
protected with a foil which should be pulled
off proper to operation.
• In case of faulty installation, the warranty is
excluded – especially for follow-up damage!
Instructions for care
Shower drains require special care. Therefore,
please observe the following instructions:
• Please clean all parts with conventional
cleaning agents. In case of strong
calcification, mild decalcifiers may be used.
• To maintain the effect of the brushed
surface, it may be freshened up from time
to time with an abrasive cleaner or a
scouring pad.
• If the care instructions are not complied
with, damage to the surface should be
expected. In this case, warranty claims can
no longer be made.
Decommissioning
• Cut off the water supply before dismantling
the product.
• Pay attention to escaping residual water.
• Disassemble the product in the reverse order
of the assembly instructions.
5