Klarstein 10033448 Bedienungsanleitung Seite 22

EN
22
Slide the housing (h) down onto the
support tube (G2). Align the positioning
protrusion on the housing with the
positioning hole (IV). Fix the housing to
the carriage with the thumbscrew (S1).
Align the grill plate holder (L) with the
recess (M) on the housing and then insert
the grill plate (K) into the housing. If you
want to remove the grill plate later, lift
it slightly to the right and pull the holder
(L) diagonally out of the recess (M).
When you later remove the housing from
the support tube (g), lightly step on the
support tube (I), hold the handles of the
housing and remove it.
Mount the cover. Hold the cover by the
handle (p) and slide the hinges (O) into
the holes (Q) of the base. When you
later remove the cover, open the cover
at a 45° angle and release the hinges
(O) from the holes (Q). The cover must
be open at a 45° angle for it to be
removed.
Insert the pin (n) of the removable
temperature controller into the socket.
You can now plug the plug into the
socket. If you remove the removable
temperature controller later, hold it by the
base, do not pull on the cable.
Note: Lay the power cord so that no
one will trip over it and remember to
remove the plug after use.