Herunterladen Inhalt Inhalt Diese Seite drucken

Cleaning And Maintenance; Charging The Rechargeable Battery; Ordering Replacement Parts - Einhell Royal AT 14,4 Gebrauchsanweisung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
ANLEITUNG AT 14,4
01.02.2005
9. Replacing the line spool
IMPORTANT! Make sure that you unplug the
rechargeable battery before replacing the line
spool (Fig. 11)!
Attach the knife guard.
Press the sides of the spool cover as shown and
remove it with the spool (Figure 8+9). Ensure
that you do not lose the spring.
Remove the empty line spool.
Thread the ends of the line on the new line spool
through the eyelets in the spool cover (fig. 10)
Fit the spool cover and spool back into the spool
mounting.
Remove the knife guard. Caution: Risk of
injury.
The line will be cut to the correct length when the
cutting head starts up again.
Caution! Catapulted pieces of nylon line may
cause injury!

10. Charging the rechargeable battery

You can remove the rechargeable battery by
firmly pressing both locking tabs (A) while pulling
out the battery (Fig. 11).
Check to see if the voltage specified on the rating
plate of the charging unit matches the mains
voltage. Connect the power supply unit (A) to the
charging adapter (B). Plug the power supply unit
into the socket outlet. The green LED on the
charging adapter lights up (Fig. 15).
Plug the rechargeable battery (C) into the
charging adapter. The red LED on the charging
adapter lights up and shows the charging
process (Fig. 15). The time it takes to fully
recharge an empty battery is approximately 4
hours, while a partially charged battery takes
correspondingly less time. The rechargeable
battery can become a little warm during the
charging process, which is normal.
If the battery pack fails to charge, please check
whether there is voltage at the socket-outlet
whether there is good contact at the charging
contacts
If the battery pack still fails to charge, we request that
you send
the battery charger with charging adapter
and the rechargeable battery pack
11:48 Uhr
Seite 15
to our customer services department.
To ensure that the NC battery pack provides long
service, you should take care to recharge it promptly.
You must recharge the battery pack when you notice
that the power of the hammer screwdriver drops.
Never allow the battery pack to become fully
discharged. This will cause it to develop a defect.

11. Cleaning and maintenance

Switch off and unplug the grass trimmer before
putting it away or cleaning it.
Remove deposits from the guard hood with a
brush.
Clean the plastic body and plastic parts with a
mild household detergent and a damp cloth.
Never use aggressive agents or solvents for
cleaning purposes!
Never spray down the grass trimmer with water.
Prevent water getting into the trimmer at all cost.
IMPORTANT: Remove the rechargeable battery
first (Fig. 11).

12. Ordering replacement parts

When ordering replacement parts, please quote the
following data:
Type of product
Article number of the product
ID number of the product
Number of the required replacement part
Rechargeable battery (14,4 V)
45.115.38
Line spool
34.051.54
GB
15

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis