OBI 210563 Original-Gebrauchsanweisung Seite 48

210563_LED_Markise_elektr.book Seite 48 Freitag, 2. Oktober 2015 5:35 17
GB
Note: For perfect operation of the awning,
we recommend you lubricate or oil the
hinged elements between the hinged
arms at regular intervals.
Note: After multiple uses of the awning,
one or both of the hinged arms may hang
at the wrong angle or unevenly. If this hap-
pens, the hinged arms must be readjus-
ted.
Error/Fault
Awning does not extend or retract
(neither with the radio remote
control nor via the switch).
Motor does not stop after the
awning has been extended or ret-
racted.
Motor stops before the awning
has been fully extended or ret-
racted.
Awning fabric is rolling up une-
venly.
After two consequent switch cyc-
les, the drive no longer operates.
Awning does not close correctly
and is not aligned with the casset-
te.
The angle of slope cannot be set.
Please contact service department directly if you
cannot eliminate the error by yourself. Please note
that the unprofessional performance of repair work
will lead to the loss of any warranty claims and that
additional costs may be incurred.
48
In many cases, small defects can lead to a malfunc-
tion. You will usually be able to deal with these your-
self. Please first look
at the table below before contacting your local OBI
store. This may save you a lot of effort and quite
often money.
Cause
Power feed has been interrupted?
Motor / switch connected incor-
rectly?
Switch defective?
Is the motor defective?
End position switch is not set cor-
rectly?
End position switch is not set cor-
rectly?
Fabric tilt is not set correctly?
Motor overheated?
Wall brackets not correctly
aligned/mounted?
Is the angle of slope set incorrect-
ly?
Are the screws of the hinged arms
loose?
Remedy
Check the power source.
Check the connections to motor /
switch.
Contact your local OBI store.
Contact your local OBI store.
Setting the end position switch.
Setting the end position switch.
Adjust the fabric slope angle.
Wait 30 minutes and allow the
motor to cool down. Then try
again.
Check and, if necessary, correct
the alignment and installation of
the wall brackets.
Check the angle of slope setting
and, if necessary, set correctly.
Check all screws to make sure
that they are tightened firmly, and
tighten if necessary.