Accessories; Technical Data; Important References - IKA RC 1 Betriebsanleitung

Accessories

Adapter cable

Technical data

Power supply:
Maximum length of
the transfer cable:
Power consumption when
the control unit is turned off:
Power consumption when
the control unit is turned on:
Protection class acc. DIN 40050:
Protection class:
Permissible ambient temperature: +5 to +40 °C
Storing temperature and
transport temperature:
Permissible relative humidity:
Dimensions: (W x D x H)
Weight:
10

Important references

1. After switching into REMOTE mode, it is no longer
possible for safety reasons to exit this operating
mode. The device will only switch back to the OFFLI-
NE operating mode in the event of a transmission
error.
2 AA batteries or 2. To make it easier to make the assignment from RC 1
2 rechargeable cells to the connected stirring mechanism when working
with multiple RC 1s, we recommend identifying RC 1
5 m and the stirring mechanism with adhesive label dots of
the same colour, for example.
Approx. 7 uA
3. Please replace the batteries or rechargeable cells as
Approx. 7 uA promptly as possible after the BATT warning appears
in the display. Depending on the type and capacity of
IP 52
the batteries or rechargeable cells you are using, they
III
can still work with the remote control unit for several
hours after the BATT warning first appears. If the vol-
tage of the batteries or rechargeable cells is no longer
-40 to +70 °C
sufficient to operate the remove control unit, actual
80 % values will no longer be transferred and the display will
turn off. If the voltage of the batteries or rechargeable
63 x 35 x 140 mm
cells is no longer sufficient to operate the remove con-
0.8 kg
trol unit while REMOTE mode is active, target values
will no longer be transferred and the display will turn
off. This means that the stirring mechanism will conti-
nue to run at the last speed that was successfully
transferred in REMOTE mode.
4. If the remote control unit will not be in use for an
extended period of time, the batteries or rechargeable
cells should be removed from the device.
RC1 0802