Kärcher RDS1 Betriebsanleitung Seite 8

Setting additional receivers for the mes-
sages
In addition to the receivers mentioned
above, messages can also be sent simulta-
neously to other telephone numbers.
Click "Other Receivers" tab.
1 List of telephone numbers
2 Fault/error messages
3 Emergency Stop/ Engine protection
switch message
4 "Other Receivers" tab.
– You can enter a maximum of 20 differ-
ent additional receivers in the list of tel-
ephone numbers.
– Each message can be sent to a maxi-
mum of 10 receivers.
– The respective message is sent to the
receivers who are checked in the col-
umn for the message with a tick mark.
Apply settings
When all settings are completed, click
"Send values" button.
Note
If an error message occurs while sending
the value, repeat the process.
Save settings on the PC: Clcik "File" in
the menu bar, click "Save File As", enter
the file name and save the file.
Exit the configuration program on the
PC.
Turn the RDS1 switch to "0".
Disconnect the connection cable to the
PC at the interface to the GSM modem.
Insert the plug for controlling the wash-
ing unit into the interface of the GSM
modem.
Turn RDS1 switch to "1" - the initializa-
tion process starts.
The initialization process is completed
after approx. 90 seconds.
The "Power" and "Status" LEDs start to
glow.
The "Signal" LED displays the strength
of the reception signal. Faster the LED
blinks, so much better is the reception.
8 English
Check function
Release the fault in the unit (for e.g.
press safety switch.
– One minute after the occurrence of the
error, the GSM modem will generate a
message. You can hear the switching of
the alarm output on the modem.
– A short while later, the recipients that
have been entered will receive a corre-
sponding SMS.
Query counter status - according to de-
scription in the chapter "Query counter
statuses".
– After 2 to 3 minutes, the response will
reach the designated receivers.
Place the lid on the casing and tighten
the screws.