CMi C-BKS 25,4-30 Originalbetriebsanleitung Seite 107

Kettensaege_Benzin_462226.book Seite 107 Mittwoch, 10. Oktober 2012 2:43 14
– Tighten the chain tightening screw (11) clockwise until the chain rests against the bottom
side of the saw rail.
– Tighten the fixing nut (12).
Running in the sawing chain
New sawing chain and rails must be re-tightened no later than after the first five cuts. This is
normal during the run-in period; the intervals between future re-adjustments will become
longer.
Filling up the fuel-oil mixture
DANGER!
Risk of injury!
Fuel is explosive!
– Before filling up, switch off the motor and let it cool off.
– Please strictly follow all safety information for handling fuel.
NOTICE!
Device damage!
Only use the prescribed fuel-oil mixture (► Usable fuel-oil mixture – p. 126).
NOTICE!
Device damage!
After filling up the fuel, you should always check whether there is still enough saw chain
oil in the saw chain oil tank.
► P. 4, item 6
– Store the device safely with the tank cover for fuel-oil mixture (4) facing upwards.
– Clean the tank cover (4) and filler neck if necessary.
– Slowly open and remove the tank cover (4).
– Fill up the fuel-oil mixture carefully. Do not spill!
– Check the seal in the tank cover (4) for damage and clean if necessary. Replace a damaged
seal immediately!
– Tighten the tank cover (4) with seal by hand.
– Wipe up any spilled fuel.
Filling up the saw chain oil
NOTICE!
Danger to the environment!
Since the saw chain oil can penetrate the environment during operation, biologically-
degradable special vegetable-based saw chain oils should be used.
► P. 4, item 6
– Lay the device securely with the tank cover for saw chain oil (5) upwards.
– Clean the tank cover (5) and filler neck if necessary.
– Slowly open and remove the tank cover (5).
– Carefully fill up the saw chain oil. Do not spill!
– Check the seal in the tank cover (5) for damage and clean if necessary. Replace a damaged
seal immediately!
– Tighten the tank cover (5) with seal by hand.
GB
107