General Use; Manual Operation - Klarstein Basel Bedienungsanleitung

GENERAL USE

Note: The appliance can be operated either by the switches located on the top right
hand side of the fire or by the supplied remote control.

Manual Operation

• This is done by operating the switches located at the top right hand side of the fire
.The standby rocker switch must first be switched on, the fire will beep to indicate
that it is powered up.
• Press the O/I button once to turn on the appliance and fire effect. A red indicator
light will show to indicate that the fire is ON. Press the O/I button for 3 seconds this
will operate the dimmer mode, hold the button down until the desired brightness is
obtained.
• Press the POWER button once for the low heat setting 1000W; press twice for the
high heat setting 2000W; press three to switch off the heat setting.
• Press the BACK LIGHT button to adjust the colors of LED decoration, 7 colors
available.
Remote Operation
The standby rocker switch located at the top right hand
side of the fire must first be switched on; the fire will
beep to indicate that it is powered up.
It takes a little time for the receiver to respond to the
transmitter. Do not press the buttons more than once
within two seconds for the fire to operate normally.
EN
23