Learning Mode - Velleman VM102 Bedienungsanleitung

LEARNING MODE

Certain modes use delays stored in DELAY1 and DELAY2. The learning
mode allows you to store two different delays, DELAY1 and DELAY2,
each from 2s up to 12 days. Default values are DELAY1 : 3 minutes and
DELAY2 : 30 minutes. You can change these delays to suit your needs.
DELAY 1 :
Push the button once.
The
relay status (LD1)
The recording starts.
Wait until the desired time has elapsed.
Push the button again, to stop recording.
The
relay status (LD1)
The
relay status (LD1)
To confirm the recorded time, press the button briefly within 5 seconds
after stopping confirm the recorded time.
DELAY 2 :
Push the button once.
The
relay status (LD1)
The recording starts.
Wait until the desired time has elapsed.
Push the button again, to stop recording.
The
relay status (LD1)
To confirm the recorded time, press the button briefly within 5 seconds
after stopping the recording.
The
relay status (LD1)
Hint : Should you wish to change delay2, without changing delay1,
simply enter a short 'dummy' time for delay1, without confirming it.
Then you can proceed with delay2.
blinks once and turns on.
is turned off and the recording stops.
will blink once.
blinks twice and turns on.
will blink twice.
will blink twice to confirm the recorded time.
Learning mode
9