walterscheid SW40 Bedienungsanleitung Seite 94

4. Align the two clamping levers (1) opposite
the inboard yoke (2) so that the clamping
levers securely support the inboard yoke.
5. Tighten the clamping lever screws (3) hand
tight (do not tighten firmly) so that both
clamping levers (1) lightly contact the in-
board yoke (2).
The inboard yoke can still easily be turned
→
by hand.
6. Grease the protrusion of the profile tube.
7. Move the profile tube (1) by hand in the
direction of the inboard yoke (2) so that the
profile tube securely engages in the inboard
yoke.
8. Clamp the profile tube tightly in the clamp-
ing profiles using the hand pump.
9. Check the alignment of the profile tube with
the inboard yoke again. If necessary, adjust
the inboard yoke so that no twisting occurs
during the press fitting.
10. Move the mounting carriage (3) forward
until the bore holes (4) and (5) of the profile
tube (1) and the inboard yoke (2) are
aligned.
REPLACING YOKE / JOINT
Fig. 31
Fig. 32
Fig. 33
43