Connecting Special Tool To The Pneumatically Driven Hydraulic Unit - walterscheid SW40 Bedienungsanleitung

5.2

Connecting special tool to the pneumatically driven hydraulic unit

INITIAL COMMISSIONING
You must first install the changeover valve (1) of the pneumatically
driven hydraulic unit on the special tool before connecting the special
tool to the pneumatically driven hydraulic unit.
Fig. 10
1. Install the changeover valve (1). See also Chapter 5.2.1 for this.
2. Secure the special tool (2) against moving on a stable worktop.
3. Connect the hydraulic hose lines (3) and (4) to the connections
of the hydraulic hand pump (5).
4. Connect the compressed air connection (6) to an external com-
pressed air source. The input air pressure of the external com-
pressed air system must not exceed 6 bar.
5. Place the two-hand control (7) next to the special tool.
The special tool is ready for use.
→
33