Moving Mounting Carriage; Moving Mounting Carriage Using Hydraulic Hand Pump - walterscheid SW40 Bedienungsanleitung

OPERATING THE SPECIAL TOOL
6.3

Moving mounting carriage

WARNING
The mounting carriage (1) is moved using the
two hydraulic cylinders (2).
The mounting carriage must be moved back-
wards in the direction of the arrow (3) for the
removal (pulling out) of a profile tube.
The mounting carriage must be moved forwards
in the direction of the arrow (4) for the mounting
(press fitting) of a profile tube.
6.3.1

Moving mounting carriage using hydraulic hand pump

The hydraulic cylinders (3) move the mounting
carriage (4) by operating the manual lever (1) of
the hydraulic hand pump (2). The position of the
changeover valve (5) determines the movement
direction of the mounting carriage.
Set the changeover valve in position A if
•
you want to move the mounting carriage
backwards.
Set the changeover valve in position B if
•
you want to move the mounting carriage
forwards.
Crushing hazard when moving the mounting carriage by the
approach of moving parts to stationary parts!
Never reach into the dangerous place while parts can still move.
•
Send any third persons out of the danger zone of the special tool
•
before you move the mounting carriage.
Fig. 16
Fig. 17
36