Installing Changeover Valve - walterscheid SW40 Bedienungsanleitung

5.2.1

Installing Changeover Valve

1. Unscrew the hydraulic hose lines (1) and
(2) from the reducing fittings (3) and (4).
2. Attach the changeover valve (1) using the
fixing bolts (2) loosely in the holes provided
on the base frame (3).
3. Screw the hydraulic tubes (4) and (5) tightly
to the reducing fittings (6) and (7).
4. Tighten the fixing bolts (2).
5. Screw the hydraulic hose line with the hy-
draulic connector (1) to the angled screw
connection (2) at the input (ENT) of the
changeover valve.
6. Screw the hydraulic hose line with the hy-
draulic sleeve (3) to the angled screw con-
nection (4) at the output (SOR) of the
changeover valve.
INITIAL COMMISSIONING
Fig. 11
Fig. 12
Fig. 13
34