INSTALLATION
Installing/Replacing the lamps
Before replacing the lamp, unplug mains lead and let the lamp cool down (approx. 5 minutes).
During the installation do not touch the glass-bulbs bare-handed! Please follow the lamp manufacturer's
notes!
Do not install lamps with a higher wattage! Lamps with a higher wattage generate temperatures the device
was not designed for. Damages caused by non-observance are not subject to warranty.
For the installation, you need four 230V/50W GU-10 lamps.
During the operation, the lamp reaches temperatures of up to 240° C.
Procedure:
Step 1: Remove the lamp protection grilles.
Step 2: If replacing the lamp, remove the old lamp from the lamp-socket.
Step 3: Insert the new 230V/50W GU-10 lamp into the lamp-socket.
Step 4: Replace the lamp protection grilles.
Attention: Never operate the device without the cloth cover. Danger of burns!
INSTALLATION
Install the device out of the public area.
If the device is to be installed overhead, the following safety instructions are binding:
Overhead rigging
Please consider the EN 60598-2-17and the respective national norms during the installation!
The installation must only be carried out by an authorized dealer!
The installation of the device has to be built and constructed in a way that it can hold 10 times the weight for
1 hour without any harming deformation.
DANGER TO LIFE!
Only install the lamps with the device switched off!
Unplug from mains before!
CAUTION!
The lamp has to be replaced when it is damaged
or deformed due to the heat!
DANGER TO LIFE!
14/31
51116100_V_2_0.DOC