Safety Instructions; Mounting Accessories; Operation - Velleman VTHD04 Bedienungsanleitung

1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle
could harm the environment. Do not dispose of the unit (or batteries) as unsorted municipal
waste; it should be taken to a specialized company for recycling. This device should be returned
to your distributor or to a local recycling service. Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing Velleman! Please read the manual thoroughly before bringing this device into
service. If the device was damaged in transit, do not install or use it and contact your dealer.
2.

Safety Instructions


Keep the cord away from the moving parts of the machine.

Switch the machine off immediately if it jams and remove the plug from the mains.

Compare the max. number of revolutions for the accessories with the number of revolutions of the
device.

When you store the device, the engine must be switched off and all moving parts must have reached
a standstill.

Do not use collets with a piece of string or such attached to it.

Never engage the collet lock button while the device is in use.

Make sure the shaft diameter of the accessory matches that of the collet nut.

Secure the work piece with a clamping device. Always be careful when handling the device.

Keep your hands away from the work piece when using the drill.

Do not use the device in a damp or wet environment or near inflammable liquids or gases.

Always wear safety goggles and ear protection. Avoid wearing loose clothing or jewellery.

Inspect the power cord and the device before every use.

Keep the device away from children and unauthorized persons.
3. General Guidelines
Refer to the Velleman® Service and Quality Warranty on the last pages of this manual.
4. Contents
● 1x electric drill ● 10x grinder stone ● 2x diamond bit ● 3x connective post ● 8x cutting disc
● 4x polishing wheel ● 4x sanding band ● 2x drill bit ● 2x collet ● 1x wet stone ● 3x sanding paper
● 1x spanner
5.

Mounting Accessories

Always remove the plug from the mains prior to assembly. Hold the collet lock button while unscrewing
the collet nut and screw the accessory in place. Hold the collet lock button while you are fastening the
collet nut. Do not operate the collet lock button while the device is still connected with the mains.
6.

Operation

Switch on the device by engaging the on-off switch. Set the desired speed with the speed dial. The
engine can burn out if too high a load is used at low speed. Only put the device down when the engine
has stopped completely. Do not store the device in a dusty environment as dust particles may penetrate
the mechanics. Always wear safety goggles when using this device.
This device should be used at high speeds for: carving and drilling, working with glass, metals and
hardwood.
This device should be used at low speeds for: polishing, delicate work, most plastic materials.
V. 02 – 10/05/2016
VTHD04
USER MANUAL
2 ©Velleman nv