Velleman VTHD21B Bedienungsanleitung

VTHD21B – Electric Drill & Engraving Set With 40 Accessories
1. Introduction
Thank you for buying the VTHD21B ! This electric drill and engraving set is the ideal tool for
precision drilling, milling, grinding, polishing, cleaning and carving. Remove rust, carve and
engrave with the VTHD21B and use it on steel, glass, timber and ceramic surfaces
Hobbyists, modellers, jewellers, opticians, etc. will appreciate this tool. The VTHD21B is
suitable for various surfaces.
2. Contents
• drill
• power supply
• diamond-mounted points (4 x)
• grindstones (2 x)
• flat grindstones (9 x)
• wirebrush
• nylon brushes (2 x)
• drills (5 x)
• sanding rolls (3 x)
• tool holder
• screwdriver
• portable grey case
3. Description
1. spindle lock
2. ON/OFF switch with speed control
3. ON/OFF switch
4. cable
5. suspension loop
6. lock button
7. drill chuck with clamping jaws
4. General Guidelines & Safety Information
Read the guidelines below carefully. Failure to comply with these prescriptions may result in
electroshock, serious injury or deadly accidents.
• Damage caused by disregarding certain guidelines in this manual is not covered by the
warranty and the dealer will not accept responsibility for the ensuing defects or problems.
• Familiarise yourself with the functions of the device before actually using it. Do not permit
operation by unqualified people. Any damage that may occur will probably be due to
unprofessional use of the device.
• Only use the device for its intended purpose.
• Do not press the spindle lock when the device is in use.
• Do not touch the bit during use
• Do not use the device if the housing is too hot
• Keep the work area clean.
VTHD21B 1 VELLEMAN