Using The Appliance; Cleaning And Care - Silvercrest SSM 200 A1 Bedienungsanleitung

Using the appliance

1) Take the fruits out of the freezer about
10 – 20 minutes before use .
2) Place a suitable bowl under the outlet 9 .
3) Remove the pusher 6 from the feed tube 2 .
4) Add the prepared fruits into the feed tube 2 .
5) Switch on the appliance using the on/off
switch 1 (position I) .
6) Applying light pressure, use the pusher 6 to
push the fruit into the appliance . The chopped
fruit will come out of the outlet 9 after a short
time . If the pusher 6 cannot be pressed further
down, remove it and add a little more fruit or
ingredients .
NOTE
► If you want to make a sorbet from several
different fruits/ingredients, add the different
fruits alternately into the feed tube 2 . In this
way, the fruits will be mixed directly .
7) Once all the fruits are chopped, stop the
appliance by moving the on/off switch 1 to
the O position .
8) Remove the power plug from the socket .
9) Unscrew the end cap 8 and pull the blade
roller 5 carefully out of the roller housing 3 .
10) Use a knife to scrape any remaining fruit
residue from between the blades on the blade
roller 5 and add this to the bowl .
11) Mix the fruit in the bowl .
You can now serve the sorbet .
■ 16 │ GB │ IE

Cleaning and care

RISK OF ELECTRIC SHOCK
► Always remove the plug from the mains power
socket before you clean the appliance .
Ensure you never submerse the motor
unit 0 in liquid, and never allow liquid to
enter the motor unit housing 0 .
WARNING! RISK OF INJURY!
► Take great care when handling the blade
roller 5 .
♦ Clean the motor unit 0 with a moist cloth after
every use . If there is heavy soiling, add mild
detergent to the cloth . Rinse detergent residues
off with clear water . Ensure that there are no
detergent residues on the appliance, and that
the appliance is completely dry before renewed
use .
♦ Remove the pusher lid 7 from the pusher 6
for cleaning purposes .
♦ Wash the pusher 6, the pusher lid 7, the
blade roller 5, the end cap 8 and the roller
housing 3 in lukewarm water with a little
detergent .
♦ Ensure that all parts are completely dry before
re-use .
NOTE
The blade roller 5, pusher 6, pusher
lid 7, end cap 8, and the roller
housing 3 can be cleaned in a
dishwasher .
Place the parts, where possible, in the upper
basket and ensure that none of the parts can
get stuck . Otherwise they could get bent or
otherwise deformed .
SSM 200 A1