Timer Setting - h.koenig KB15 Bedienungsanleitung

5. While the icemaker is on, verify water level periodically. If water pump can't inject water,
the ice maker will stop automatically, and the "
window.
Fill water up to the level mark and press "ON/OFF" button two times again to turn on the
unit again. Allow the refrigerant liquid inside the compressor at least 3 minutes to settle
before restarting.
6. The ice maker automatically stops working when the ice basket is full and the "
symbol will display in the LCD display widow.
7. Change water in the water reservoir every 24 hours to ensure a reasonable hygiene
level.
If unit isn't in use, drain all water left in the tank.

TIMER SETTING

Timer Delay Time Range: 0.5-19.5 hours.
Default Delay Time: 3 hours.
When the unit is running, you can set the unit with OFF-TIMER to let the unit stop running
after your set delay time.
And when the unit is stopped, you can set the unit with ON-TIMER to let the unit start to
run automatically after your set delay time, then when you go back home or have a dinner,
you can enjoy the happy life that this ice-maker give to you.
How to set the timer
Press the TIMER button first, the default "3.0H" delay time will flash in LCD display window,
then press the SELECT button to select your desired delay time. Each press SELECT
button one time, the flashing delay time will increase 0.5 hour, and if you always press the
SELECT button for mor than 3 seconds, the delay time will chang very quickly. Then after
5 seconds flashing, the delay time digit will change from flashing to always displaying,
means the timer program has been set.
How to cancel the timer
When the unit has been set with the timer or during the timer setting process, press the
TIMER button, then the delay time digit will disappear, mean the timer set has been
cancelled.
CLOCK DISPLAY & THE CORRECT TIME
Clock
Time
This unit is supplied with CLOCK dipalying function.
If the displayed time is not correct, you can adjust it to the correct
digit through the CLOCK and SELECT button.
First press the CLOCK button once, the digit meaning hour will
start to flash first, then you can press SELECT button to change
it, each press will increase 1 hour. Press the CLOCK button
again, the digit meaning minute then will start to flash, and also
press the SELECT to change it. Then press the CLOCK the third
time to confirm it, and now it display the new correct clock. And
during adjusting process, after 5 seconds flashing, the digit will
automaticall change to always displaing, also means the new
clock has been set.
" symbol will flash in LCD display
"