TFA RATIO Bedienungsanleitung Seite 7

TFA_No_30.3034.10_Anl_10_12
RATIO
– Wireless thermometer
• Unauthorised repairs, modifications or changes to the product
are prohibited.
• The product is not be used for medical purpose or for public
information, but is intended only for home use.
Caution!
Risk of injury:
• Keep these instruments and the batteries out of reach of chil-
dren.
• Batteries must not be thrown into the fire, short-circuited,
taken apart or recharged. Risk of explosion!
• Batteries contain harmful acids. Low batteries should be
changed as soon as possible to prevent damage caused by a
leaking battery. Never use a combination of old and new bat-
teries together, nor batteries of different types. Wear chemi-
cal-resistant protective gloves and glasses when handling
leaked batteries.
Important information on product safety!
• Do not place the unit near extreme temperatures, vibration or
shock.
• Protect from moisture.
• The outdoor transmitter is protected against splash water, but
is not watertight. Choose a shady and dry position for the
transmitter.
5. Elements (Fig. 1)
5.1 Receiver (Display unit)
LCD
A1: Clock
A2: Indoor temperature
A3: Outdoor temperature
A4: Outdoor temperature wave icon
A5: Channel number
Buttons
B1: "SET"/"MIN/MAX" button
B2: "RESET"/"CH/+" button
12
25.10.2012 13:41 Uhr Seite 7
RATIO
– Wireless thermometer
Housing
C1: Wall mount hole
C2: Battery compartment
C3: Stand (fold out)
5.2. Transmitter (Fig. 2)
D1: Wall mount hole
D2: Battery compartment
D3: Support for table standing
D4: Support for wall mounting
6. Getting started
3.1 Insert batteries
• Open the battery compartment of the display unit and the
transmitter (screwed) and place both instruments on a desk
with a distance of approximately 1.5 meter. Check that no other
electronic devices are close.
• Insert the batteries 2 x 1,5 V AAA into the battery compartment
of the transmitter and immediately afterwards 2 x 1,5 V AA in
the display unit, observing the correct polarity.
6.2 Reception of outdoor temperature
• The display unit automatically starts scanning the 433 MHz signal
to register the thermo sensor unit after batteries are inserted.
flashes on the LCD of the display unit.
• Note: DO NOT PRESS ANY KEY during the learning period.
After outdoor temperature is displayed you can place your
remote sensor outdoors at the final destination. If the outdoor
temperature is not displayed or if any key is pressed before the
outdoor temperature signal is received and when changing
batteries you will need to follow the battery installation pro-
cedure again. Please wait 10 seconds before inserting the
batteries again.
6.3 Setting of clock
• Hold "SET" button for 2 seconds. The 24Hr indicator is flashing.
Press "+" button to choose 12 HR or 24 HR system (24 HR: tem-
perature in °C/12 HR: temperature in °F).
13