Troubleshooting - EINHELL HGG 110 Bedienungsanleitung

Anleitung HGG 110-171-300_SPK7
9. Trouble Shooting
Problem Cause
Motor doesn't start No electricity
Piezo doesn't ignite Electrode incorrectly adjusted
No gas at burner - Gas valve is closed
- Gas cylinder is empty
- Gas hose or connection leaks
Burner ignites, flame is - The thermoelement was not
extinguished as soon as the gas - warm enough
valve is released - The safety thermostat
- - switches off
Burner goes out while in use - Gas flow too high
- Air input too low
Important!
Have repairs carried out only by specialist workshops or ISC.
21.08.2006 10:28 Uhr Seite 13
Remedy
- Check electrical outlet
- Check mains cable
Check electrode and precisely
set according to diagram
- Open valve
- New gas cylinder
- Locate point of leak with soap
- foam and repair
- Repeat ignition procedure
- while pressing in the gas
- valve knob
- Allow the heater to cool for a
- few minutes and reignite
- Have the pressure regulator
- inspected and replace if
- necessary
- Check the suction grid and
- clean
- Inspect ventilator
GB
13