Safety Instructions; Required Tools And Material; Prior To Installation; Checking The Functions - sunfun 26245889 Gebrauchsanweisung

Safety instructions

• Technical knowledge is required to
install the awning. Do not install
this awning yourself if you are:
• uncertain whether the awning
can be mounted in the chosen
place.
• do not understand the instruc-
tions or parts thereof.
• do not have the necessary
tools.
• do not have the required tech-
nical knowledge.
• Never alter the design or configu-
ration of the system without con-
sulting the manufacturer or author-
ized representative, since this can
create a dangerous situation.
• Do not install the awning if you find
damaged parts or parts are miss-
ing.
• When extended, various forces,
including wind and rain, affect the
awning. These sometimes consid-
erable forces must be absorbed by
the awning and transferred to the
structure via the mounting brack-
ets. Excessive force can act on the
mounting anchors when the awn-
ing is under extreme load. There-
fore, prior to installation, check the
load-bearing capacity of the
mounting structure and, if neces-
sary, take the necessary measures
to ensure that the holders are prop-
erly secured. Contact a specialist
in your area if the mounting is not
secure.
• The awning is only suitable for pro-
tection from the sun. It may not be
used in strong wind (wind speed:
>10.8 m/s), rain, hail or snow. If
such conditions prevail, roll-up the
awning immediately.

Required tools and material

The mentioned tools and materials are
not included in the scope of delivery.
This is non-binding information and
values for orientation purposes. The
quality of the material depends on the
individual conditions on site.
• Pencil/awning tools
• Ruler
• Drill
• Masonry drill
• Spirit level
• Hexagonal wrench (5 mm and
6 mm)
• Ladder (platform ladder)
• Tape measure

Prior to installation

– Check all screws for correct seat-
ing before using the awning.
– Carefully remove the awning from
the box and peel the polystyrene
trips off of the awning.
– Remove the plastic bags and plas-
tic bracket on the awning and place
the awning carefully on the ground
to prevent it from being damaged
from scratches or otherwise soiled
during work.

Checking the functions

– Be sure to check the functions of
the motor with the remote control
before installing the awning. Insert
GB
English
205