Positioning; Cleaning / Disinfection - Electrolux MRF 280/35 Bedienungsanleitung

5
The room in which the equipment is to be installed must be dry and sui-
●
tably aired, avoiding direct exposure to the sun or positioning near a heat
source.
Make sure that the equipment is positioned in a stable manner and on a
●
flat surface. It must never be put next to other equipment. By loosening
or tightening the feet, they can be adapted to the desired level.
For exceptional functioning there must be good airing around the equip-
●
ment. Make sure that in the lower, rear and top part of the equipment
there are no obstacles to air circulation. The free space around the appli-
ance must be at least 75 mm.
Models MRF400/35 and MRF600/35 should be attached to the wall
●
using the catch provided, to ensure they do not overturn.
Models MRF400/35 and MRF600/35 are fitted with an automatic defro-
●
ster. To ensure optimum defrosting, the built-in defrosting dial should be
set to the present time before commissioning.
The door handle on models MRF401/86 and 601/86 has been moved by
●
90° at the factory end to facilitate packaging and transporting, and
should be turned during installation in accordance with the diagram
across.
6
Before using clean or disinfect all the internal and external parts. Use only delicate detergents. Completely avoid using aggressive,
●
corrosive or abrasive detergents, steel wool, abrasive sponges or chemical solvents. Be careful that during cleaning, liquids do not
filter into the ventilator housing.
If the internal equipment is made of steel, there are plastic foils on different parts of the doors and drawers. Remove these foils befo-
●
re starting the refrigerator.
P
OSITIONING
C / D
LEANING ISINFECTION
- 5 -
ON
AC FAIL
OFF
AC OK °C Temp
S E T
Alarm COLD
WARM WARM COLD
Mem ory
COLD
WARM RES
MEM
S E T
actual time
1
3
4
2