Safety Information - Lightmaxx LED NANO PAR Bedienungsanleitung

Safety information

Thanks for using our products. For your safety,
please read the User's Manual carefully before your operation.
This Manual includes the important information of installation, operation, safety instruction. Please
install and operate as requested in the Manual, meanwhile, please keep the manual for any
unexpected requirements.
1. This product is only operated by adult; please put it where the child can not touch it.
2. Please check if the voltage is accordance with the rated power or nor before installation, and
please note the total electric circuit load.
3. This device is for indoor use only, the light must be kept dry and avoided to use under the
Moist, Overheat or Dusty surroundings. If there is any water or other liquid in the product,
please cut off the power and contact your supplier.
4. Make sure that the power cable does not shrink volume, and the insulation cover of power
cable will not be scratched by anything sharp.
5. Please cut off power when doesn't use or before cleaning, maintenance the light.
6. The light doesn't include any spare parts for repair. In order to avoid danger, please do not
open and change the product structure by yourself.
1. Product cleaning
A. Clean the output acrylic board and product body every 2 weeks, or smoke dust accumulation
will weaken the brightness of the light.
B. Use soft cloth with water to clean , do not with organic solvent ,such as ethyl alcohol
C. Clean the cool fan each month
2. Product maintenance
Product maintenance must consider the below terms.
A. All screws mounted on the lamp must reliably tightened, check and replace the corroded
screws.
B. Ensure fixed point for installation without any deformation
C. Check if the power cable is damage, and if the insulation layer is wear down.
D. To ensure good connection of the various parts of the circuit, and to avoid unnecessary
accidents coursed by bad electrical connections, the detailed inspection of the light must be
make by the authorized electrical engineer every three months.
6