Specifications; Operation - Ryobi CSS-1801M Bedienungsanleitung

GB
F D
SPECIFIC SAFETY RULES
Do not charge battery tool in a damp or wet
■
location. Following this rule will reduce the risk of
electric shock.
For best results, your battery tool should be
■
charged in a location where the temperature is
more than 10°C but less than 38°C. Do not store
outside or in vehicles.
Under extreme usage or temperature conditions,
■
battery leakage may occur. If liquid comes in
contact with your skin, wash immediately with
soap and water, then neutralize with lemon juice
or vinegar. If liquid gets into your eyes, flush them
with clean water for at least 10 minutes, then seek
immediate medical attention. Following this rule will
reduce the risk of serious personal injury.

SPECIFICATIONS

Motor
Switch
No load speed
Collet
Collet Adaptor
Battery pack (not included)
Charger (not included)
FEATURES
1. Switch
2. Spindle Lock
3. Depth Adjustment Ring
4. Collet Nut
5. Adjusting Knob
6. Bit
7. Tab
8. Wrench
9. Screw
10. Nut
11. Handle
12. Pivot Point Knob
13. Threaded Ring
14. Circle Cutter Arm
15. Adaptor
16. Battery Pack (Not included)
17. Latches
18. On
19. Off
20. Tighten
21. Loosen
22. Adjust up or down
E I P NL
18 V
On/Off Switch
-1
22,500 min
6.35 mm
3.2 mm
BPP-1815M/BPP-1817M
BC-1800/BC/1815-S
S DK N FIN GR
English
ASSEMBLY
REMOVING DEPTH ADJUSTMENT RING (Fig. 2)
Remove battery pack from spiral saw.
■
Place wrench in tab on depth adjustment ring.
■
Depress spring-loaded tab.
■
Lift depth adjustment ring off tool.
■
ASSEMBLING CIRCLE CUTTER (Fig. 3)
Remove battery pack from spiral saw.
■
Attach handle with screw provided.
■
Attach pivot point knob with nut provided.
■
ATTACHING CIRCLE CUTTER (Fig. 4)
Remove Battery Pack From spiral saw.
■
Assemble circle cutter if necessary. Refer to
■
"Assembling Circle Cutter."
Remove bit if necessary. Refer to "Inserting/
■
Removing Bits" in this manual.
Place adaptor under depth adjustment ring.
■
Note: Make sure the adaptor fits snugly.
Place circle cutter arm on top of depth adjustment
■
ring.
Screw threaded ring onto adaptor, securing circle
■
cutter arm.
Insert bit. Refer to "Inserting/Removing Bits" in
■
this manual.

OPERATION

10
H CZ RUS RO
WARNING
Do not allow familiarity with tools to make
you careless. Remember that a careless fraction
of a second issufficient to inflict serious injury.
WARNING
Always wear safety goggles or safety glasses
with side shields when operating tools. Failure to
do so could result in objects being thrown into
your eyes, resulting inpossible serious injury.
WARNING
Do not use any attachments or accessories not
recommended by the manufacturer of this tool.
The use of attachments or accessories not
recommended can result in serious personal
injury.
PL SLO HR TR