Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
guard using the blade guard lever. Remove the saw blade from the inner
flange and pull it out.
• Clean the saw blade flanges thoroughly before mounting the new saw blade. Wipe
a drop of oil onto the inner and outer flange where they will touch the blade.
• Mount the new saw blade onto the spindle and against the inner flange.
Replace the outer flange and tighten the blade bolt.
The direction in which the blade rotates has to be the same as the
!
direction of the arrow marked on the upper blade guard.
Ensure that the spindle lock button is released.
Before using the saw again, check that the safety devices are in good
WARNING
working order.
IMPORTANT: After replacing the saw blade, make sure that the saw blade runs freely
by turning the blade by hand.
Plug the machine into a power supply and run the saw under no load to check that it
runs smoothly before using it to cut any material.
i. Switch on and off (Fig. 9)
Fig. 9
3. Operation for working
a. Making a Cut
• Mark the line of cut on the work piece.
• Adjust the depth of cut and bevel angle as required.
• When making 90° cross or rip cuts, align your line of cut with the outer blade guide
notch on the base of the saw.
• When making 45° bevel cuts, align your line of cut with the inner blade guide notch
on the base of the saw.
• Rest the front edge of the base on the work-piece. Make sure the power cord is out
of the way of saw the blade and not in the line of cut.
• Start the motor by depressing the lock-off button and squeezing the trigger switch.
• The tool is equipped with a lock-off
button to avoid unintentional starting.
• To switch on, depress the lock-off
button and squeeze the trigger switch.
To switch off, release the trigger
switch.
CAUTION: Allow the blade to come to a
complete standstill before setting the saw
down.
96 | 97
GB
Werbung
Inhaltsverzeichnis
