Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
c) Lower guard may be retracted manually only for special cuts such as
"plunge cuts" and "compound cuts". Raise lower guard by retracting handle
and as soon as blade enters the material, the lower guard must be released.
For all other sawing, the lower guard should operate automatically.
d) Always observe that the lower guard is covering the blade before placing
saw down on bench or floor. An unprotected, coasting blade will cause the
saw to walk backwards, cutting whatever is in its path. Be aware of the time it
takes for the blade to stop after switch is released.
Saw Blade Safety Warnings:
1. Only use saw blades recommended and only use saw blades if you have
knowledge of how to use and handle them.
2. Pay attention to the maximum rotational speed. The maximum rotational
speed marked on the saw blade shall not be exceeded. Where stated, the
speed range shall be adhered to.
3. Do not use saw blades which are cracked. Repairing is not permitted.
4. Use the supplied saw blade only for cutting of wood, never for metal or plastic.
5. Longer period using may lead overheating the blade tips. Therefore take
breaks of approx. 15 minutes on a regular basis to let the blade tips cool down.
Residual risks
The following risks are typical for the use of this machine:
• injuries caused by touching the rotating parts, especially the blade
• injuries caused by breakage of the saw blade
In spite of the application of the relevant safety regulations, the implementation of
safety devices and the use of the tool in accordance with the instructions, several
residual risks cannot be avoided, e.g.:
• Impairment of hearing when using inappropriate hearing protection.
• Impairment of the respiratory system if no appropriate protective dust mask is
used.
• Injuries to eyes, if no appropriate protective goggles are used.
• Risk of accidents caused by the uncovered parts of the rotating cutting blade.
• Risk of injury when changing the blade.
• Risk of squeezing fingers when opening the guards.
Safety instructions for Plunge type saws
Guard function
a) Check guard for proper closing before each use. Do not operate the saw if
guard does not move freely and enclose the blade instantly. Never clamp
or tie the guard so that the blade is exposed. If saw is accidentally dropped,
guard may be bent. Check to make sure that guard moves freely and does not
touch the blade or any other part, in all angles and depths of cut.
Werbung
Inhaltsverzeichnis
