Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
c. Adjust the bevel angle (Fig. 3)
!
Always ensure that the saw is switched off and unplugged from the
power supply before making any adjustments.
WARNING
Fig. 3
NOTE: Always make a trial cut in a scrap piece of material along a guideline to
determine how much you should offset the blade from the guideline to make an
accurate cut.
d. Using the parallel fence (Fig. 4)
!
Always ensure that the saw is switched off and unplugged from the
power supply before making any adjustments.
WARNING
Fig. 4
•
The saw can be adjusted to cut at any
angle between 0° and 45°. When
making 0° and45° bevel cuts, there is
a notch in the saw base to help you
line up the blade with the line of cut.
Align your line of cut with the inner
blade guide notch on the base of the
saw when making 45° bevel cuts.
•
Loosen the bevel locking knobs
located at the front and back of the
base plate. Tilt the body of the saw
until the required angle is reached
using the bevel scale as a guide.
•
Tighten the bevel locking knobs to
secure the base plate.
• The parallel fence allows you to make
parallel cuts in a sheet of wood, all at
the same width.
• Loosen the parallel fence locking knob.
• Slide the parallel fence through the
parallel fence slots in the base plate.
• Adjust the parallel fence to the
required width and secure it in position
with the parallel fence locking knob.
• Ensure that the parallel fence rests
against the wood along its entire length
to give a consistent parallel cut.
Werbung
Inhaltsverzeichnis
