Ayce 1500 W Originalbetriebsanleitung Seite 95

e. Using the laser (Fig. 5)
!
Before proceeding to use the laser line system, ensure that the
Additional Safety Rules for Laser Lights section is read and fully
understood.
WARNING
Fig. 5
• Always ensure the laser beam is aimed
at a sturdy work-piece without
reflective surfaces. i.e. wood or rough
coated surfaces are acceptable. Bright
shiny reflective sheet steel or the like
is not suitable for laser use as the
reflective surface could direct the
beam back at the operator.
• Only turn the laser beam on when the
tool is on the work-piece.
• Mark the line of the cut on the work-
piece.
• Adjust the depth of cut and bevel angle
as required.
• Rest the front edge of the base on the
work-piece.
• Push the laser light on/off button to "I"
position to switch on the laser beam.
• Align the beam with the line on the
work-piece.
• Start the motor and always let the
blade reach full speed before you begin
to cut into the work piece.
• Slowly push the saw forward using
both hands, keeping the red laser light
beam on the line of cut.
• After completing your cut, release the
trigger switch and allow the blade to
come to a complete stop.
• Do not remove the saw from the work-
piece while the blade is moving.
• After you finish your work, push the
laser light on/off button to "O" position
to switch off the laser beam.
94 | 95 GB