Din Rail Mounting - AB Quality MicroLogix 1761-NET-ENIW D series Installationsanleitung

6 MicroLogix™ Ethernet Interface
Mounting
The 1761-NET-ENI(W) must be mounted in the
vertical position, as shown. Horizontal mounting is
not recommended due to thermal considerations.
Allow 50 mm (2 in.) of space on all sides for
adequate ventilation. See page 4 for operating
temperature specification.
protective debris strip

DIN Rail Mounting

Installation
DIN
Rail
Publication 1761-IN007B-MU-P
ATTENTION
1. Mount your DIN rail.
2. Snap the DIN rail latch into the closed position.
3. Hook the top slot over the DIN rail.
4. While pressing the unit against the rail, snap the
Latch
unit into position.
side
Do not remove the protective debris strip
until after all the equipment in the panel is
mounted and wiring is complete. Once
wiring is complete, remove protective debris
strip. Failure to remove strip before
operating can cause overheating.
top
ETHERNET
RS232
FAULT
TX/RX
IP side
PWR
CABLE
EXTERNAL
bottom