AB Quality MicroLogix 1761-NET-ENIW D series Installationsanleitung Seite 5

WARNING
Use only the following communication cables and replacement connectors in Class
I Division 2 Hazardous Locations.
Environment Classification
Class I, Division 2 Hazardous
Environment
Explosion Hazard
• Substitution of components may impair suitability for Class
I, Division 2.
• Do not replace components or disconnect equipment
unless power has been switched off and the area is
known to be non-hazardous.
• Do not connect or disconnect connectors or operate
switches while circuit is live unless the area is known to
be non-hazardous.
• This product must be installed in an enclosure. All cables
connected to the product must remain in the enclosure or
be protected by conduit or other means.
• The ENI(W) must be operated from an external power
source.
• All wiring must comply with N.E.C. article 501-4(b).
Communication Cable and Connectors
1761-CBL-PM02 Series C
1761-CBL-HM02 Series C
1761-CBL-AM00 Series C
1761-CBL-AP00 Series C
MicroLogix™ Ethernet Interface
2707-NC8 Series B
2707-NC9 Series B
2707-NC10 Series B
2707-NC11 Series B
Publication 1761-IN007B-MU-P
5