Configuring Videostudio - ADS TECH PYRO A/V Link Handbuch

Configuring VideoStudio

PYRO A/V Link allows you to capture video from camcorders, VCRs, and
VCD/DVD Players into the high-quality DV format. To ensure a smooth
installation and setup with VideoStudio 7, please follow the steps outlined
below.
1.) Turn on your PYRO A/V Link and be
certain that it has been properly detected
by the Windows Device manager as
outlined on the previous pages.
2.) Connect your video source to the audio
and video jacks on A/V Link.
3.) Check your video source to ensure it is
powered on and that you have a tape of
disk playing video.
4.) Click the Capture Step at the top of the
VideoStudio program. You should see
"PYRO A/V Link" listed in the Source field
in the Capture Settings panel.
5.) DV should be the video capture format. If
you wish to capture as MPEG video, read
the section on "Direct Capture of MPEG"
later in this manual.
6.) Click on File.
7.) Then click "Change Capture Plug-in" – Be
sure that Ulead Direct Show Capture
Plug-in is selected
8.) Click PLAY on the Preview Window and
you will see your video previewing.
Note: PYRO A/V Link supports many video input sources. PYRO A/V Link has the ability to
automatically sense and select the active video input whether it be Composite (RCA), SVideo
(S-VHS) or Component video inputs. Video will be captured from what ever video source is
connected with a live video signal.
PYRO A/V LINK 34
Check that your device is listed under Source