Connecting For Digital To Analog Conversion - ADS TECH PYRO A/V Link Handbuch

Add a Preview Monitor to this Configuration
You can easily connect a TV to the audio video output jacks on the PYRO A/V
Link to monitor your video dubbing process.
1.) Connect an RCA or S-VHS video cable between the PYRO A/V Link and
your TV RCA or S-VHS Video input jacks.
2.) Connect Right and Left audio cable between the PYRO A/V Link Right and
Left audio jacks and your TV audio inputs.
3.) Switch the TV to accept an external video input.
If you have a digital camcorder you can use the PYRO A/V Link to convert the
digital content into an analog video signal so it can be recorded on your VCR.
1.) Connect your digital camcorder or DV deck to the 4 pin DV In jack on the
front of the PYRO A/V Link.
2.) Connect a video cable from the RCA or S-VHS OUT jacks on the back of
the PYRO A/V Link and into an external video input (RCA or S-VHS) on
your VCR
Note: S-VHS provides a higher quality video recording than an RCA
cable. S-VHS is recommended if your camcorder or VCR offers this
connection.
3.) Connect an audio cable to the Left and Right RCA audio OUT jacks on
the back of the PYRO A/V Link to the external audio inputs (RCA) on your
VCR.
Note: If you are recording back to a camcorder, you may need to use
the cables provide by the camcorder manufacturer.
Connecting for Digital to
Analog Conversion
PYRO A/V LINK 27