Connecting For Analog Record And Preview At The Same Time - ADS TECH PYRO A/V Link Handbuch

Connecting for Analog Record and
You can preview and record video to a VCR at the same time as long as the VCR
allows for audio and video to be passed through it. Check and test your VCR
to ensure that has audio and video inputs and outputs and that it allows pass
through of audio and video while recording.
1.) Connect a video cable from the RCA or S-VHS OUT jacks on the back of
the PYRO A/V Link and into the Video In on your VCR.
2.) Connect an RCA or S-VHS cable to the Video Out on your VCR to an
external video input (RCA or S-VHS) on your TV.
3.) Connect an audio cable to the Left and Right RCA audio OUT jacks on the
back of the PYRO A/V Link to the audio inputs (RCA) on your VCR.
4.) Connect an audio cable between the Left and Right RCA OUT on your
VCR to the Audio INPUTS on your TV.
5.) Apply Power to the VCR – You may have to change the TV/VCR switch on
the VCR to allow pass through.
6.) Apply Power to the TV and switch the TV to accept the external video
source. (Check your TV manual if you are not sure how to do this.)
The only non-valid connection configuration for video pass-through would be RCA or S-Video
In and Component Video out. This is because the component jacks are auto-switching and
auto-sensing. If you are bringing analog video in, the Component Jacks switch to inputs, if
you are exporting video out the Component Jacks switch to video output.
Preview at the same time
PYRO A/V LINK 22