Operation - JABSCO 52600 Series Handbuch

IF YOU ARE NOT FAMILIAR WITH APPLICABLE
CAUTION
ELECTRICAL STANDARDS, HAVE THE UNIT INSTALLED BY A
QUALIFIED ELECTRICIAN.
Figure 5.
7 Inches Max
Battery
Switch
+
12V DC Battery
CAUTION
Suggested wiring information is given as a reference. For proper
information, please reference ABYC E-11, AC and DC Electrical
Systems on Boats guidelines.
Model No Voltage
52600-0092
52600-0094
52600-0292
52600-0294
CAUTION
Motor case could get hot during extended
operation. Prolonged contact with skin may cause a burn.
CAUTION
Install a Pumpgard
location (for inspection and cleaning) between the tank and
pump inlet in order to protect valves from debris.

Operation

• Fill water tank
• Open all faucets
• Turn pump switch "ON"
Figure 6.
• When water is free of air, turn all faucets off beginning with
the faucet closest to the pump (Figure 6)
Important: Do not operate the pump more than 15 minutes
continuously.
Fire hazard. Wiring must comply with
WARNING
!
applicable electrical standards and include
a properly sized fuse or circuit breaker.
Improper wiring can cause a fire resulting in
injury or death.
Helm
Console
Panel
Switch
Main
35 AMP
Main Breaker
Ring Terminals 5/16" Eye
–
Max Amp
Draw
12 V 35
24 V 20
12 V 30
24 V 15
Initial Start Up
Demand Off
Demand On
Butt Splice
Red (+)
Black (–)
Com Bus
Open Flow
GPM (LPM)
7.0 (26.5)
7.0 (26.5)
7.0 (26.5)
7.0 (26.5)
strainer in an accessible
TM
Switch Max PSI
(bar)
60 (4.1)
60 (4.1)
40 (2.7)
40 (2.7)