Jet DC-1100CK Gebrauchsanleitung Seite 6

Attach inlet guard (A, Fig 3) to fan housing using 8 pan
head screws (B).
Press the inlet port (C) and secure with provided screw.
Attention:
To reduce the risk of injury from moving parts, always
keep inlet port covered with the cap provided, if not
connected to a hose.
Collector Housing:
Attach 3 support brackets (A, Fig 4) to the base using 6
hex cap screws (B) and washers.
Install the housing (A, Fig 5) with 6 hex cap screws (C).
Fig 3
Fig 4
Fig 5
Vortex Cone Assembly:
Mount the cone support bracket (I, Fig 6) to the housing
with 4 hex cap screws (J) and nuts.
Mount the Vortex cone (K) from beneath with hex cap
screw (H), washer and nut.
Hose Assembly:
Attach the hose (A, Fig 7) with 2 provided clamps (B).
Fig 6
Fig 7