Startup / Operation - BOMANN DU 773 IX Bedienungsanleitung, Garantie

• For mounting the hood drill in total 8x mounting
holes with approx. 8 mm diameter into the wall.
Insert the supplied dowels
• Screw in the screws 2x ST4*40 for the hood body
so far that they project approx. 4 mm out of the
wall.
• Before inserting the hood, affix the connection
piece with the non-return valves from the top of
the extraction duct.
For exhaust mode (Fig. For exhaust mode (Fig. 2): For exhaust mode (Fig. For exhaust mode (Fig.
• Hereupon a flexible exhaust hose (supplied) with
an inner diameter of 150 mm must be attached.
• Hang up the hood body. Check the secure hold
and the horizontal position. Tighten the screws
through the hood body.
• Additionally, secure the housing with the screws
(Fig. 2) (Fig. 2) (Fig. 2) (Fig. 2)
2x ST4*30
• Fix the bracket (with angle) for the upper shaft
termination with the screws 2x ST4*40
• Fasten the outer (lower) shaft with the bracket
(without angle) using the metal screws 2x ST4*8
(Fig. 4). (Fig. 4).
(Fig. 4). (Fig. 4).
• Put the shaft unit on and fasten the shaft bracket
with the screws 2x ST4*40
For the exhaust mode: : : : For the exhaust mode For the exhaust mode For the exhaust mode
• Check the correct position of the exhaust hose
and connect it with the outlet opening.
• Pull up the inner shaft and fix the shaft cover to
the side with the bracket using the screws
(Fig. 6) (Fig. 6)
2x ST4*8 (Fig. 6) (Fig. 6) .
Installing the activated carbon filter for recirculation Installing the activated carbon Installing the activated carbon Installing the activated carbon
mode mode mode mode
• Remove the aluminum grease filter (see "Clean-
ing the aluminum grease filter).
• Place the carbon filter onto the air
intake of the extraction duct.
Make sure that the mounting pins
(Fig. 1) (Fig. 1)
(Fig. 1) (Fig. 1) .
2): 2): 2):
.
(F (F (F (Fig. ig. ig. ig. 3) 3) 3) 3)
(Fig. 5) 5) 5) 5) (Fig. (Fig. (Fig.
.
filter for recirculation filter for recirculation filter for recirculation
on the extraction duct engage the mounting slots
of the carbon filter. Turn the filter clockwise until it
clicks into place.
• Reinstall the aluminum grease filter.
Electrical connection Electrical connection Electrical connection Electrical connection
WARNING: WARNING:
WARNING: WARNING:
• The installation to the mains supply must conform
to the local standards and regulations.
• Improper connection may cause to an electric
shock shock shock! shock
• Do not modify the appliance plug. If the plug does
not fit properly to the outlet, let install a proper
outlet by an authorized specialist.
• The accessibility of the power plug must be en-
sured to disconnect the appliance from the power
supply in case of emergency.
• Ensure that your mains power corresponds with
.
the specifications of the appliance. The specifica-
tions are printed on the rating label.
• Connect the mains cable to a properly installed
and earthed wall outlet.
• If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.
The cooker hood is operated via push buttons:
Switch the operation off
Power level low
Power level medium
Power level high
Switch the lighting on / off
19

Startup / Operation

Startup / Operation
Startup / Operation Startup / Operation
electric electric electric