Preparing The Cables - HBM VKK1R-4 Montageanleitung

10
3

Preparing the cables

For optimum results, proceed as follows:
D Remove the outer sheath of the cable and depending on the cable
diameter, expose the braided screen for about 8 ... 15 mm.
D Push the cap nut and the bladed insert with the sealing ring onto the cable.
D Bend the braided screen outward at right angles (90°).
D Crimp the braided screen over towards the outer sheath of the cable, i.e.
fold it a further 180° .
D Slip the intermediate connection piece on as far as the braided screen,
quickly turning it to and fro around the cable axis.
D Push the bladed insert with the sealing ring into the intermediate connection
piece and engage the locking element.
D Firmly tighten the cap nut
cap nut
shielded cable
Fig. 3.1: Preparing a connection cable
HBM
bladed insert
sealing ring
VKK1-4 / VKK1R-4
intermediate connection
braided screen
A2326-1.1 en/de/fr